Rice Lake 920i Installation Manual V4.0 - Manual (Page 43)

Configuration 37
SERIAL Menu
Parameter Choices Description
Level 2 submenus
PORT 1
PORT 2
PORT 3
PORT 4
…
PORT x CMD
PROGIN
KEYBD
KDBDPRG
SCALE
IND SC
DISPLAY
IQUBE Specifies the type of data received by the port:
CMD: Remote command input
PROGIN: Programmable input
KEYBD:
Remote keyboard input
KBDPRG: Passes keyboard scan directly to user program for use by PortxCharRecieved
handler
SCALE: Legal-for-trade serial scale input
IND SC: Industrial (non-legal-for-trade) scale input
DISPLAY: Display data input for remote units in local/remote configurations
IQUBE2: iQUBE 2
serial scale input
KEYBD and KBDPRG are available only on Port 2; SCALE, IND SC, and IQUBE2 are available
only on Ports 3 and 4 and higher (expansion ports).
NOTE: The keyboard interface is not hot-pluggable. Power-off the 920i before plugging the
keyboard cable into the Port 2 connector.
Level 3 Submenus Port 1–Port 32
BAUD 9600
19200
28800
38400
57600
115200
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the port.
NOTE: The maximum baud rate for ports on serial expansion cards (port number greater than
4) is 19200.
BITS 8NONE
7EVEN
7ODD
8ODD
8EVEN Selects number of data bits and parity of data transmitted or received by the port.
STOP BITS 2
1 Selects number of stop bits transmitted or received by the port.
ECHO ON
OFF Specifies whether characters received by the port are echoed back to the sending unit.
RESPONSE ON
OFF Specifies whether the port transmits replies to serial commands.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the port.
EOLDLY 0
0–255 End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
HANDSHK OFF
XONOFF
HRDWAR Specifies whether XON/XOFF flow control characters or hardware handshaking is used.
Hardware handshaking is available only on Port 2.
Table 3-6. Serial Menu Parameters