Rice Lake BCi Belt Scale - Installation & Operation Manual Version 2.00 - Manual (Page 59)

BCi Installation & Operation Manual - Run Sequence 53
6.0 Run Sequence
Once configuration of the supervisor’s parameters are all entered, the BCi should be ready for daily operation.
The following sub-sections give an overview of how you will use the BCi during a normal work shift. The main
screen is shown below.
Figure 6-1. BCi Main Screen
Beyond the supervisor mode parameters there are other softkeys that the user can access to run the BCi. Those
softkeys include:
• Target Settings
• Diagnostics
• Reset Totalizer
• Start Fill
6.1 Target Settings
Press the Target Settings softkey to access this parameter. The target settings parameter allows the operator to
change the target value of the fill and the fixed preact value. Press the Target softkey to access that parameter.
Enter a new target value and press enter to save that value.
Figure 6-2. Target Setting Screen
The fixed preact value will not have any use if the preact length is set in configuration mode. To access the fixed
preact softkey, press the softkey and enter the preact value in tons. Press
enter to save that value.
SCALE #1
Target
Settings
11/23/2011 08:13AM
Rate
Speed
Load
Totalizer
Tn/Min
Ft/Min
lb/Ft
T
6.2
5.0
3.0
167.8
Reset
Totalizer
Start Fill Diagnostics
Supervisor
Mode
SCALE #1
Fixed
Preact
11/23/2011 08:13AM
Rate
Speed
Load
Totalizer
Tn/Min
Ft/Min
lb/Ft
T
6.2
5.0
3.0
167.8
Target Exit =>