Rice Lake Survivor 390HE Hostile Environment Digital Indicator - Manual (Page 13)

Configuration 9
3.1.3 Front Panel Configuration
The 390HE indicator can be configured using a series of menus accessed through the indicator front panel when
the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Figure 3-2. Front Panel Key Functions in Setup Mode
Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 3-2).
The
UNITS
( ) and
PRINT
( ) keys scroll left and right (horizontally) on the same menu level;
ZERO
( ) and
GROSS/NET
( ) move up and down (vertically) to different menu levels. The TARE key ( ) serves as an Enter
key for selecting parameter values within the menus. A label over each of these keys identifies the direction
provided by the key when navigating through the setup menus.
Menu Menu Function
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, and digital
filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate indicator. See Section 4.0 on page 20 for calibration procedures.
SERIAL Serial Configure serial port.
PROGRM Program Set power-up and standby modes, counting scale functions, regulatory mode, unit ID and
consecutive number values.
P FORMT Print Format Set print format used for gross, net, and counting scale tickets. See Section 7.0 on page 27
for more information.
VERSION Version Display installed software version number.
Table 3-1. 390HE Menu Summary
Switch between
primary and
secondary units
Send data to
serial port
Set gross weight
to zero
Switch between
gross, net, and
piece count mode
Acquire tare
NORMAL MODE KEY FUNCTIONS
T
MODE ENTER SAMPLE PRINT
ZERO GROSS
NET
TARE UNITS PRINT
B/N Units T