Rice Lake Survivor 390HE Hostile Environment Digital Indicator - Manual (Page 14)

10 SURVIVOR 390HE Installation Manual
Figure 3-3. Setup Mode Menu Navigation
To select a parameter, press or to scroll left or
right until the desired menu group appears on the
display, then press to move down to the submenu or
parameter you want. When moving through the menu
parameters, the default or previously selected value
appears first on the display.
To change a parameter value, scroll left or right to
view the values for that parameter. When the desired
value appears on the display, press to select the
value and move back up one level.
To edit numeric values, use the navigation keys to
select the digit and to increment or decrement the
value. Press to enter the numeric value, then use the
or key to adjust the decimal point position, if
necessary. Press again to save the value and exit the
parameter (see Figure 3-4).
Figure 3-4. Editing Procedure for Numeric Values
3.2 Menu Structures and Parameter Descriptions
The following sections provide graphic representations of the 390HE menu structures. In the actual menu
structure, the settings you choose under each parameter are arranged horizontally. To save page space, menu
choices are shown in vertical columns. The factory default setting appears at the top of each column.
Most menu diagrams are accompanied by a table that describes all parameters and parameter values associated
with that menu. Default parameter values are shown in bold type.
NOTE:
Some characters cannot be accurately represented on the 7-segment front panel LCD display. Section 8.4
on page 33 lists the 7-segment character set and the alphanumerics they represent.
1 st Level
Parameter
Default value
2 nd Level
Parameter
Value Value Value
1 st Level
Parameter
2 nd Level
Parameter
When moving through values below the first menu level, press to return to the level
above. Press or to move to the next parameter on the level above.
When editing numeric values, press or to change th e
digit selected. Press or to increment or decrement the
value of the selected digit. Press to save the value.
2 0 0 0 0 0
After entering the value, press or to change the decimal
point location. Press again to save the value and exit the
parameter.
2 0 0 0 0 0