Rice Lake SURVIVOR 420HE Hostile Environment - Installation Manual - Manual (Page 24)

Table 3-5. Serial Menu Parameters
SERIAL Menu
Parameter Choices Description
Level 2 submenus
EDP BAUD
BITS
TERMIN
EOLDLY
ECHO Specifies settings for baud rate, data bits, termination characters, end-of-line delay and echo
used by the EDP port.
PRINT BAUD
BITS
TERMIN
EOLDLY
ECHO Specifies settings for baud rate, data bits, termination characters, end-of-line delay and echo
used by the printer port.
STREAM OFF
EDP
PRN Selects the serial port used for continuous transmission. See Section 7.3 on page 40 for
information about the
420HE continuous data format.
STRRTE INDUST
LFT Specifies stream rate. Stream rate can be set to industrial or legal for trade.
PRNDES EDP
PRN Print destination. Selects the port for data transmission when the PRINT key is pressed or the
KPRINT EDP command is sent.
PRNMSG OFF
ON Print message. Default will be off. Whenever the print key is pressed and data is sent out, the
word PRINT is momentarily put on the remote display.
Level 3 Submenus EDP Port and Printer Port
BAUD 9600
19200
38400
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the EDP or printer port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the EDP or printer port.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the EDP or printer port.
EOLDLY 000
number End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
NOTE: An EOL may be required for continuous transmission at slower baud rates to ensure the
receiving buffer is empty before another string is transmitted
ECHO OFF
ON This command enables or disables echoing of the serial commands sent to the indicator.
20 420HE Installation Manual