Rice Lake TC Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 17)

12 RL-TC Series Operation Manual
4.2 Description of Functions
Item Set Value Description
Bar graph display
1..b.G..
0 Disable
☆ 1 Enable
Limit function
2.SEL
☆ 0 Disable
1 Enable
D
is
pl
ay
ed
on
ly
w
hen
lim
it
func
ti
on
is
ac
ti
v
at
ed
Judgement
condition
21.Co.
☆ 1
Always judge (judges even when the balance is unstable)
2
Judge only when the balance is stable (does not judge
if the balance is unstable)
Judgement
range
22.L
0
Ranges beyond +5 graduation is judged (ranges +5
graduation or below, including negative ranges, are not
judged.)
☆ 1
The entire range is judged (the entire range, including
the negative, is judged).
Number of
points for
judgement
23.P 1 One-point setup (judges between OK and LO)
☆ 2
Upper-limit and lower-limit values are set up (judges
among HI, OK and LO).
Auto-zero
(zero-tracking)
3.A.O
0 Disable
This function automatically sets the zero point
exactly to zero to prevent slight deviations.
☆ 1 Enable
Auto power-off
4.A.P.
0
Disable (balance operates
continuously) This function is available
only when the balance is
battery-operated.
☆ 1
Enable (balance powers off in
approximately three minutes)
Response speed
5.rE.
0 Measurement by consecutive weighings.
1
Fast
↓
Slow
2
☆ 3
4
5
Stability parameters
6. 5.d.
1
Wide (mild)
↓
Narrow (strict)
☆ 2
3
4
Interface
7. 1.F.
0 Disable input/output
☆ 1 Six-digit numeric format
2 Seven-digit numeric format
Setup of units of
measurement to be
displayed
Register selected
measuring units with
Function key.
☆ 1 01 [ g ]
☆ 2 14 [ ] (ct)
15 [ ] (oz)
16 [ ] (lb)
17 [ ] (ozt)
18 [ ] (dwt)
* 19 [ ► Lower right ] (grain)
Items marked ☆ are the default factory settings.
☆ 1～ ☆ 5: default settings [
81.5.u
]～[
85.5.u.]
*
Not available in TC-12K.