Rice Lake TC Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 24)

RL-TC Series Operation Manual 19
3
Adding samples
Add approximately an equal number of
samples as the number currently
displayed. Add them gradually, in
groups of approximately the same
number, until the number of samples is
approximately double. The additional
samples need not be counted.
4 Saving the samples Press the Target key.
After the unit weight of the samples has
been saved, the display begins to flash,
indicating that the Memory Update
Method is still running.
5 Repeating the addition and saving of samples Repeat steps 3 and 4. The eventual
total number of samples to be saved
should be approximately 1/5 to 1/2 of the
number of samples to be measured.
6 Terminating the sampling Press the Memory key.
The balance saves the unit weight and
returns you to measurement mode.