Torbal AGS100 250C PRO Manual - Manual (Page 15)

15
3. Once the temperature has been entered, press the ENTER key to confirm the selection.
Note : A table of materials with their recommended Drying Time and sample weight is included in this
manual.
8.4. Sample Quantity
Note : This parameter must be set when using the analyzer in the Short Mode. See the Notes and
Parameter descriptions in Section 7.2.
1. Use the “<>” navigation key to select Samples Quantity and press the ENTER key.
2. Use the “<>” navigation keys again to select the desired number of samples to be taken. The choices
are: OFF, 2 samples, 3 samples, 4 samples, and 5 samples. Once the desired selection has been
made, press the ENTER key confirm the selection.