Torbal AGS100 250C PRO Manual - Manual (Page 3)

3
WARNING:
• If a mistake creates a dangerous situation, hit the STOP key and it will terminate the heating
immediately.
• Use caution when touching any of the parts that rise to high temperatures during testing. Wear
protective gloves when removing hot samples, even when using the pan handle (it can get very
hot).
• Use the cover handle to open and close the Drying Chamber.
• Always use forceps or needle-nose pliers to remove the hot disposable sample pan from the larger
permanent pan.
• When loading a new sample into the Drying Chamber using the pan handle, make sure the
disposable sample pan and sample are centered and that the sample has been leveled. The
maximum sample height must be less than 10 mm.
• Be sure the Analyzer is in an area with good air circulation (to diffuse the heat generated by the
Drying Chamber), relatively low (less than 85%) or controlled humidity (for accurate
measurements), and an ambient temperature between 18ºC and 30ºC.
Legal regulations forbid disposal of electronic
equipment in waste containers.
• Please return this device to the point of purchase or another company that
specializes in recycling of waste electronic components.