Torbal AGS100 250C PRO Manual - Manual (Page 24)

24
Important Caution Note: Do not touch the top surfaces of the Moisture Analyzer’s Drying
Chamber or any internal parts either during or soon after use. As the parts and surfaces will be very
HOT, allow adequate time for the unit to cool. Be sure to read and follow all Caution Procedures
listed in Chapter 1.
7. When the analysis is finished, “END” will be displayed in the lower right corner of the LCD. The Final
result will remain displayed. To clear the result and prepare the unit for the next analysis, press the F5
key STOP.
Caution: Always use the forceps supplied with the unit when handling a used Disposable Pan.
Important Note: Before starting a new analysis press F5 (STOP), replace the disposable pan and
perform a TARE to make sure parameters m, t and m0 are cleared (set to 0).