B&C Technologies PF Series - Manual (Page 18)

Chapter 6
Operation
6.1 Powering the Machine
After mains power is applied, wait until the control has fully booted (approximately 3 minutes).
As soon as the start screen is visible, the machine can be started.
6.2 Emergency Stop
When the emergency stop is activated, power is removed from the outputs of the control.
The machine will not operate until the emergency stop button is released and the reset button on
the touch screen is pressed.
The control signals ’Emergency Stop - Reset’ symbol in middle of the screen. Refer to figure 6.1 on
page 15.
6.3 Overload Relay
If a motor is shutdown due to a thermal overload the ’Check Thermo’ screen appears. The circuit
breaker must be checked. Refer to figure 6.2 on page 15.
14