B&C Technologies PF Series - Manual (Page 21)

If the machine is not running the belts can be manually started by pressing the shown
button. The belts run as long as the shown button is pressed.
6.6 Control Dispaly
6.6.1 Pages
Some display modes are built up with pages. These pages can be displayed in turn by pressing
left and right arrow icons.
6.7 Settings
6.7.1 Password Protection
To prevent malfunctions, the parameter settings and manual switching of the control outputs are
protected with a password.
The control has multiple password levels. If a button is greyed out and doesn’t respond if pressed,
this function is not available in the current password level. The password level is displayed in the
footer on the panel The following is a listing of the various password levels:
1. User (level 0): During normal work no password is needed.
2. Operator (level 20): parameters of the control can be adjusted (Password 369).
3. Engineer (level 60): Full access to the control (Use Caution!) (Password: 7250).
6.7.2 Password input
To enter a password, navigate to the ’Settings’ page via the left and right arrows. When the pass-
word page is displayed, touch in the password input field on the display. The keyboard will then
be displayed, and the password can be entered. After the password is correctly entered, the pass-
word level will be displayed in the bottom center of the display. If the correct password is entered,
the functions of the current password levels are available. These functions remain available until
the password resets (see ’Password reset’ in the next section).
17