B&C Technologies PF Series - Manual (Page 23)

If you change the parameters of the currently running program the new values are
used immediately. This means that the new values are used from the next article fed
into the machine after the change is made.
If you change the program number on the page ’Program Parameters’, the currently
running program is not changed. This must be done on the main page.
6.8 Switching Outputs Manually
The test mode is for testing the inputs and outputs (with the corresponding functions) of the ma-
chine. The test mode is password protected and can only be turned on if no error messages are
displayed on the screen. If the currently entered password fulfils the requirements, the test mode
can be activated. By looking at the button you see if this mode is activated or not (if the button is
pressed the test mode is active. Additionally an icon appears in the footer).
As soon as the test mode is activated an output on the page ’Digital Outputs’ can be selected and
switched on or off by pressing it again.
By leaving the test mode the outputs are switched to their previous state.
If the password is reset, the test mode exits, and the outputs are switched to their
previous state.
6.9 Setup Mode
The setup mode helps an engineer to adjust the pneumatic of the machine. The desired outputs
can be selected. They are switched on and off according to the given times. This mode is password
protected.
6.10 Miscellaneous
Calibrate touchscreen If you press ’Calibrate’ on the page ’Settings’, the touchscreen will go in a
calibration mode. 4 crosses are displayed one after another, which have to be pressed.
A calibration must be made if the raster, which registers the pressure, does not correspond with
the displayed drawing. This means everytime if you have to press any more besides a button to
activate it.
19