B&C Technologies PF Series - Manual (Page 22)

6.7.3 Password reset
The password resets (times out) when:
1. If a user presses the button ’Reset Password on the page ’Settings’
2. If the emergency stop is pressed
3. The password times out after 60 minutes (after the password input is accepted) for the ’Op-
erator’ level. The level ’Engineer’ does not time out - the control must be restarted.
If the password times out while in test mode, the activated test mode (see chapter ’Switching
Outputs Manually’) terminates. Refer to section 6.8 on page 19.
6.7.4 Machine Parameters
To change machine parameters, press the button ’Machine’ on the page ’Settings’. The page ’Ma-
chine settings’ appears. There are three possibilities to select a parameter:
1. Press the number of the selected parameter. Using the keypad which appears the number of
the desired parameter can be entered.
2. The parameter number can be decreased or increased by the arrow buttons
3. Change the page of the parameter overview. By pressing on the parameter list, a bar with
four buttons appears. With the arrow buttons you can select the desired parameter and
activate it with the confirm button. If you press the cancel button the bar disappears.
To change the value of the selected parameter, press the current value of the selected parameter.
Using the keypad which appears the new value of the parameter can be entered.
6.7.5 Global Parameters
To change global parameters, press the ’Global’ button on the ’Settings’ page . The page ’Global
settings’ appears. Changing global parameters is the same as changing machine parameters.
6.7.6 Program Specific Parameters
To change program parameters, press the ’Program’ button on the ’Settings’ page . The page
’Program Parameters’ appears. Changing program parameters is the same as changing machine
parameters.
The difference between the machine and global parameters is that it matters which program is
currently selected. The program you want to change can be selected with the keypad or with the
arrow buttons.
18