Hit Products LogicPLUS S 42/128 - Manual (Page 18)

LogicPLUS-S Two-Wire Controller
18
18
Position 6 | | Calendar | | Function Button Odd-Even
note: The calendar automatically resets all programs to day 1, today, when “Master Clear” is
activated. The calendar automatically resets to today, day 1, when any value in “Calendar”
is changed. The calendar can be manually changed to any day including today in Position
5, “Total Run Time.” day value has to be equal to or less than “calendar” number of days.
except when using a Seven day Calendar, display will show day of the week.
(example) SUn., MOn., Wed., and so on.
1. Odd / even: May be accessed by pressing Function Key Set 5.
2. Use Set 1 to select program use Set 3 and 4 to On or OFF.
3. note: To exit the Odd / even feature both Odd and even must be set to OFF.
Press the function button to exit.
4. note: Runtimes must not go beyond 11:59 pm.
definitions:
Start: This is the day of the calendar that the program will start. This will be automatically set upon
initial programming or set by the user. This is day 1 of the calendar, the day you set up the calendar
or programmed the program or let the auto-calendar set up the calendar.
Run: The total run time of the program has carried over into the second or more days and the
program will be running these days to complete.
Off: The user has programmed in additional days that the program will not be active.
note: The number of days that the calendar automatically sets up is determined as follows:
The number of hours from 12:00 midnight to the first start time plus the total run time, di-
vided by 24 hours will equal the number of calendar days.
For calculating the calendar for “Run” Times over 24 hours. This example is for 56 hours Run Time
per Program.
example: If a start time is 8:00 am, then the first calculation would be 8 hours plus a total run time
of 56 hours for a grand total of 64 hours, divided by 24 hours would equal a 2.67 day calendar, the
display would show a 3 day calendar, as follows, day 1 STRT, day 2 RUN and day 3 RUN. If you
wanted to irrigate every 4th day, use set 2 to expand the calendar from 3 days to 4 days, day 4
would show OFF.
note: in cases not using a 7 day calendar and the information in the calendar is changed,
the “day” in the “Total Run Time” position will reset to “day”.
note: To further understand the diamond setting for calendar, read the diamond setting on
page 29.