Hit Products LogicPLUS S 42/128 - Manual (Page 45)

45
LogicPLUS-S Two-Wire Controller 45
Pedestal/Box Mounting instructions/dimensions

























































INSTRUCTIONS:
1. MOUNT PEDESTAL BASE USING THREE MOUNTING HOLES.
2. REMOVE THE REAR PANEL FROM PEDESTAL IF NECESSARY TO
INSTALL WIRING 3/4 INCH KNOCKOUTS ARE AVAILABLE ON BOTH SIDES.
3. BACK OUT TWO TOP SCREW AND REMOVE REMAINING
FOUR SCREWS FROM TOP OF PEDESTAL.
4. MOUNT STAINLESS STEEL BOx TO PEDESTAL.
A) REMOVE CONTROLLER FACE PLATE AND STAINLESS
STEEL PANEL FROM STAINLESS STEEL BOx.
B) MOUNT BOx TO PEDESTAL UTILIZING THE
TWO MOUNTING HOLES (KEYHOLES).
5. REPLACE THE FOUR SCREWS REMOVED IN STEP 3 AND TIGHTEN
ALL 6 SCREWS.
6. BRING THE WIRING THROUGH THE BACK OF THE BOx AND SECURE.
7. MAKE WIRING CONNECTIONS TO CONTROLLER (SEE LOGIC WIRING
INSTRUCTIONS) AND REPLACE CONTROLLER PANEL INTO STAINLESS
STEEL BOx AND REPLACE THE STAINLESS STEEL PLATE.
8. REPLACED PEDESTAL REAR PANEL IF NEEDED.
NOTE: KEEP FIELD WIRES SEPARATED FROM AC POWER WIRES
INSIDE PEDESTAL.