Hit Products LogicPLUS S 42/128 - Manual (Page 40)

LogicPLUS-S Two-Wire Controller
40
40
dBC-BR Wire Connector installation instruction
1
2
3
4
5
WARNING! Turn off power before installing or removing connector.
All electrical work should be done according to appropriate electrical codes.
IMPORTANT NOTICE: Before utilizing the product, the user should
determine the suitability of the product for its intended use. Hit
Products Corp. expressly disclaims the implied warranties and
conditions of merchantability and fitness for a particular purpose.
In no case shall Hit Products Corp. be liable under any legal
theory, including but not limited to contact or strict liability, for
any direct, indirect, special, incidental or consequential damages
resulting from product use.
Manufactured by Hit Products Corp., Lindsay, Ca, USA
www.hitproductscorp.com
mtd-0012
DBC-BR Wire Connector Installation Instructions
Insert Brass Connector with Screw showing in the opening in Handle.
Insert all Wires into Brass Connector.
Use Screwdriver to tighten Screw very firmly on Wires while
holding splice in Handle. Pull Wires to check for integrity of connection.
Repeat process if any loose Wires.
Remove Wires and Brass Connector form Handle.
Insert Wires to bottom
of Tube.
Bend Wires to fit under
Cap and securely snap
Cap to fully closed
position.
5/8"