Hit Products LogicPLUS S 42/128 - Manual (Page 41)

41
LogicPLUS-S Two-Wire Controller 41
SCREW
SCREW
SCREW
SCREW
LogicPLUS Two Wire
Hand Held Programmer
LogicPLUS
For LogicPLUS Receivers Only
Set / #
Test / #
ON / # Enter
LP-HHRP
LogicPLUS Two Wire
Hand Held Programmer
LogicPLUS
For LogicPLUS Receivers Only
Set / #
Test / #
ON / # Enter
LP-HHRP
LogicPLUS Two Wire
Hand Held Programmer
LogicPLUS
For LogicPLUS Receivers Only
Set / #
Test / #
ON / # Enter
LP-HHRP
LogicPLUS Two Wire
Hand Held Programmer
LogicPLUS
For LogicPLUS Receivers Only
Set / #
Test / #
ON / # Enter
LP-HHRP
LOGIC HAND HELD RECEIVER PROGRAMMER
PROGRAMMING INSTRUCTIONS
WARNING: WHEN PROGRAMMING A RECEIVER AT THE VALVE BOX BE SURE TO DISCONNECT BOTH
RED RECEIVER WIRES FROM THE FIELD WIRING AND ONE BLACK RECEIVER WIRE GOING TO
THE SOLENOID
1. To turn on the Programmer press the ON/ENTER button (after 20-30 seconds of no activity
the programmer will turn off). The display will read:
RED RED
SET DECODER ID
TEST DECODER ID
2. Clip the 2 red leads of the Programmer to the 2 red leads of the Decoder/Receiver to be
programmed. Be sure the black leads of the Receiver/Decoder are not touching.
LP-RP
RECEIVER
Gray
Box
LED
1
RED
RED
BLK
BLK
RED RED
KEEP
SEPARATED
3. To Program a Logic Receiver:
a. To Program a Decoder/Receiver press
the top button. The display will read:
SET DECODER ID
SET ID XXX ENTER
3. To Test a Logic Receiver
a. To Test a Decoder/Receiver ID, press the:
middle button. The display will read:
TEST DECODER ID
ID XXX ENTER
b. Use the top 2 buttons to scroll up or
down to the required number.
c. Press Enter.
d. The LED in the Receiver/Decoder will
flash 3 times.
e. The receiver is now programmed.
5. This unit will display "LOW BATTERY":
To replace the battery, remove the six (6) screws from the back cover. Replace the 9V battery
and replace the back cover and screws. Be sure to place red wires properly.
TA
G
W
A
RN
IN
G