CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 16)

2-2 L351 10/100BASE Media Converter
Table 2-1. SW2 and SW3 Functions
Position Function On Off
SW2-1/
100 User Port 100M Speed Select 100M speed Select 10 M speed
SW2-2/A User Port Auto-Negotiate Enable automatic data
rate and duplex selection Follow SW2-1 and 2-3
settings
SW2-3/F User Port Full Duplex Select full duplex Select half duplex
SW2-4/N Not Used N/A N/A
SW3-1/S SBMC Enable SBMC Disable SBMC
SW3-2/L LLF, Extension to User Enable Link Loss
Forwarding (LLF)
propagating from
Extension Port to User
Port Disable LLF
propagating from
Extension Port to User
Port
SW3-3/U LLF, User to Extension Enable LLF propagating
from User Port to
Extension Port Disable LLF
propagating from User
Port to Extension Port
SW3-4/E Extension Port LLE/RMTF
(if SBMC is disabled) or
RMTF only (if SBMC is
enabled)
Enable LLE for
Extension Port (Disables
RMTF) Disable LLE for
Extension Port (Enables
Remote Fault)
Note: Factory default hardware control setting for User Port Auto-Negotiate is ON. SMBC
shipping configuration is disabled.
2.2.1 Install the L351 in a BAM Host
Each BAM can hold up to two L351s. Follow these steps to install the BAM and the L351:
1. Insert a BAM into any available slot of either a 1000 or 1001 chassis. Slide the BAM into the
rails and push it firmly into the backplane, then tighten the captive screws. If you encounter
resistance, pull the BAM out and check that no connector pins are bent.
2. Insert the L351 into an unused slot in the BAM. Slide the L351 into the rails and push it firmly
into the backplane, then tighten the captive screw. If you encounter resistance, pull it out and
check that no connector pins are bent.
If you encounter more difficulty, contact Canoga Perkins at (800) 360-6642 for technical assistance.
Note: The L351 and BAM are hot-swappable and can be inserted or removed without disrupting
data transfer in other application modules.