CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 52)

EdgeAccess Universal Chassis System
4-28 L351 10/100BASE Media Converter
4.5.9 SNTP Client Configuration Screen
The L351 can be set up to synchronize the system date and time to an SNTP server. When the L351
contacts the SNTP server to synchronize the time, the event appears in the System Log, whether or
not the SNTP server responds. If you choose to not use SNTP to maintain the date and time, or do not
have access to the Internet or an SNTP server, see paragraph 4.10, Utilities, to manually set the date
and time. To set up synchronization with SNTP, follow these steps:
1. At the System Configuration Menu, type 7, SNTP Client Configuration and press <Enter>.
2. At the SNTP Client Configuration screen, type the number for a parameter and press <Enter>,
then follow the prompts at the bottom of the screen. When you are done setting that parameter,
press <Enter> to return to the SNTP Client Configuration screen.
3. When you have completed configuring the SNTP parameters, press <Esc> to return to the
System Configuration Screen.
Figure 4-24. SNTP Client Configuration Screen
--------------------SNTP CLIENT CONFIGURATION-------------------------
1. Sntp Client UTC Offset (hours) : 0
2. Sntp Client Observe DST : Disabled
Sntp Client DST Starts At : 01/01/1970 00:00
Sntp Client DST Ends at : 01/01/1970 00:00
3. Sntp Client Sync Interval (minutes): 5
4. Sntp Server IP Address : 0.0.0.0
Sntp Server Retries : 3
Sntp Server Timeout (seconds) : 5
Sntp Server Priority : 1
5. Sntp Server IP Address : 0.0.0.0
Sntp Server Retries : 3
Sntp Server Timeout (seconds) : 5
Sntp Server Priority : 1
Select [1-5]:
-------------------------------Messages-------------------------------