CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 44)

EdgeAccess Universal Chassis System
4-20 L351 10/100BASE Media Converter
Table 4-5. SNMP Configuration Parameters Description
Item Description
1) Ethernet IP Address
Subnet Mask
Default Gateway
Enter the IP address for access through the Ethernet network, the
mask that sets the network ID part of the IP address, and the address
of the network node that connects to another network
2) SLIP/PPP IP Address Enter the IP address for access through SLIP or PPP
3) Serial Port Config Set the type of serial port connection: VT100, SLIP, or PPP
4) BOOTP Enable this if the module needs to obtain its IP address from a
BOOTP server; when the unit has an IP address, disable BOOTP
5) Telnet Security Enables or disables checking if Telnet host is listed in the host table.
Default is disabled, which allows access to all hosts
6) Test IP Address
Test Subnet Mask
The Test IP address is not available with the N525.
7) Inband Management
Port Set the port that will receive management packets; can be Ext. only,
User only, Both ports, or No Management
8) Management VLAN Enable or disable the Management VLAN
9) Management VLAN
Number Set the number for the VLAN; range is 0-4095
The SNMP agent allows access to up to 24 Host IP addresses listed in the Host Table. Set up the Host
informzation for the L351 on the Host Table screen (see Figure 4-18).
1. Type 2 to access the Host Access Table screen.
2. To add a host, type 1 and press <Enter>, then follow the prompts at the bottom of the screen
to enter values for these parameters:
a. Managing Host IP
b. IP Mask Size
c. Telnet Access
d. FTP Access
e. SNMP Access
f. SNMP Protocol
g. V1/V2c Read Community
h. V1/V2c Write Community
i. V1/V2c Access Level
3. To delete a host, type 2 and press <Enter>. Use the space bar to move down the Host Access
list, press <Enter> to delete a highlighted entry. Press <Esc> to return to the Host Access
Table screen.
4. To return to the IP/SNMP Configuration menu, press <Esc>.