CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 36)

EdgeAccess Universal Chassis System
4-12 L351 10/100BASE Media Converter
4.5.2 Functional Configuration Screen
The Functional Configuration report and menu provides information about the hardware, with options
to set software control. You can view the options for the Remote module, you can set options for both
the Local and remote L351 module. For details about how RMTF, LLE, and LLF interact, see Section
3.4. Two reported hardware switch functions depend on the type of module:
1. An L351 with a UTP User port ignores the LLE User settings.
2. An L351 with a fiber User port ignores the User Speed/Duplex settings.
In addition, a system that supports 1000 BASE UTP ports allows only one port set to Master; all
others must be set to Slave.
To access the Functional Configuration screen, follow these steps (see Figure 4-7 and Table 4-2):
1. From the Main Menu, type 1, System Configuration, and press <Enter>. The System
Configuration menu appears.
2. From the System Configuration menu type 2, Functional Configuration, and press <Enter>.
3. At the Functional Configuration screen, type the number for an item and press <Enter>, then
press <Space> to cycle through the options and press <Enter> to select an option for the local
or remote L351.
4. To return to the System Configuration menu, press <Esc>.
Figure 4-7. Functional Configuration Screen
-----------------------------FUNCTIONAL CONFIGURATION-----------------
Local Remote 9145
Chassis/Slot Standalone
User Port Speed/Duplex Link Down Link Down
Switch Settings:
User Port Speed 100M
User Port Autonegotiation Enabled
User Port Duplex Full
Side Band Mgmt Enabled
LLF Extension to User Enabled
LLF User to Extension Enabled
RMTF Disabled
1) Configuration Option Control Software
2) User Port Speed/Duplex Autonegotiate 100M/Full
3) RMTF Disabled Disabled
4) Link Loss Fwd Disabled Disabled
5) Remote Configuration
Select [1-5]:
-------------------------------Messages-------------------------------