Dynon Avionics EFIS-D10A Pilots Users Guide - Manual (Page 38)

EFIS Operation
when passing through 500 feet from the target altitude. The target altitude is considered captured when altitude is withi
150 feet of the target. Flying more than 200 feet away from the target triggers a short audio alert and alternates the bug in
red and yellow as a visual alert. When below the 200-foot window, a rising tone is sounded; when above th n
e 200-foot
ow, a descending tone is sounded. The visual climb or descend alert clears after recapturing the target altitude or 30 wind
seconds F
. lying back inside the 150-foot capture window re-arms the alerter without any user interaction.
If your system is configured to output voice via an HS34 or AP74 module, the voice alerts “climb” or “descend”
t altitude and then adjust the
th
riggers and the bug alternates red and yellow.
button in
r
an
lists or data panels. By default the EFIS-D10A is loaded with the following 5 categories:
are sounded, instead of tones. Additionally as you approach the altitude bug, the voice alert “altitude” is
sounded when crossing 500 feet away from the bug.
To simulate the altitude alerter on the ground, SYNC the altitude bug to your curren
altimeter setting up or down. When you adjust the altimeter setting enough that
window, observe that the audio alert t
e altitude is outside the 200-foot
If you do not wish to use the altitude alerter function, push the ALM
the BUGS menu to toggle it to OFF.
LISTS – Using Checklists and Data Panels
The Dynon Support Program allows you to enter your own checklists or select from included data panels. These
checklists and data panels can then be uploaded to your EFIS-D10A for quick access from the main menu or from you
screen rotation. Data panels and checklists can be included beneath 5 user-configurable categories and each category c
contain up to 5 check
EFIS-D10A Pilot’s User Guide 5-5
CHKLIST, RADIO, POH, EMGNCY and MISC. Each checklist/data panel can contain up to 14 lines of text and 40
characters per line.