Dynon Avionics EFIS-D10A Pilots Users Guide - Manual (Page 45)

EFIS Operation
is the maximum positive g-force experienced by the EFIS-D10A since reset. The middle row, labeled CR, is the current
g-force experienced by the EFIS-D10A. The bottom row, labeled MN, is the minimum g-force experienced by the EFIS-
the max and min g-force values to the current g-force value, enter the EFIS > INFO menu and press the RSET G
button.
in EFIS-
D10A firmware version 3.0 and higher, VSI can be displayed as a graphical indicator next to the altitude tape.
d to
, or to any other device in a DSAB system, you may manually set the outside
y input via the OATSET menu, a box is displayed around the
D10A since reset.
To reset
VSI (Rate of Climb)
The vertical speed indicator (VSI) consists of a single line with your current rate of climb or
descent. If you are currently gaining altitude, an up arrow is displayed to the right of the vertical
speed value. If you are losing altitude, a down arrow is displayed to the right of the vertical speed
value. The units of VSI are feet/minute. Note that in the MODERN display (EFIS > SETUP > STYLE), found
OAT (Outside Air Temperature)
The EFIS-D10A supports the connection of an OAT to its EDC-D10A. If no OAT is connecte
the EFIS-D10A
temperature.
The OAT info item displays 3 lines of text, containing outside air temperature, density altitude,
and true airspeed. To use the TAS/DA calculator without an OAT installed, manually enter the outside air temperature in
the EFIS > OATSET menu. When a temperature is manuall
temperature in the info item, as shown in the image above.
When multiple units are connected to a DSAB network, one primary OAT is shared between all units. This can
be an OAT connected to an EFIS or an EMS. If the EFIS-D10A is displaying an OAT provided by another unit
in the system, changing the OAT type or install status on the EFIS-D10A has no effect on the displayed OAT.
5-12 EFIS-D10A Pilot’s User Guide