Dynon Avionics FlightDEK-D180 Pilots Users Guide - Manual (Page 39)

EFIS Operation
5-2 FlightDEK-D180 Pilot’s User Guide
The BARO setting can be changed using the HS34’s VALUE knob, depending on the configuration settings in
EFIS > SETUP > HSI > VALUE KNOB.
The BARO setting can be changed using the AP74’s VALUE knob, depending on the configuration settings in
EFIS > SETUP > AP > VALUE KNOB.
The current indicated altitude is preserved across a power cycle. When powered down, the instrument saves the indicated
altitude. When it is powered up again, the instrument automatically adjusts the altimeter setting by exactly enough to
preserve that saved value. This is not a replacement for modifying the altimeter setting by the pilot before takeoff; it
makes it very close to the correct value, minimizing the amount of adjustment needed. To turn auto-set on or off, enter
the EFIS > SETUP > BARO menu and set the ADJUST AT BOOT option to ON or OFF.
BUGS – Setting Bug Markers
You can set a marker – or “bug”– to display on any or all of
the three tapes. To do this, enter the EFIS > BUGS menu (or
EFIS > AP > BUGS, if an AP is installed), and choose the type of bug to configure: HDG (heading), TRK (track), IAS
(Indicated Airspeed), or ALT (altitude). Note that if a bug is not currently displayed, changing its set value causes it to
display on the relevant tape.
HEADING / TRACK
In the BUGS menu, press HDG/TRK. Note that, if an autopil
is installed, this bug will display as either HDG or TRK
depending on the autopilot’s mode of operation. ot
he display of the heading bug on the HSI page as well.
Press the
TOGGLE button to turn on or off the heading or track bug
display on the horizontal heading tape. Note that this affects t