Lists – using checklists and data panels, Lists – using checklists and data panels -5 – Dynon Avionics FlightDEK-D180 Pilots Users Guide User Manual
Page 42
EFIS Operation
when passing through 500 feet from the target altitude. The target altitude is considered captured when altitude is withi
150 feet of the target. Flying more than 200 feet away from the target triggers a short audio alert and alternates the bug in
red and yellow as a visual alert. When below the 200-foot window, a rising tone is sounded; when above th
n
e 200-foot
ow, a descending tone is sounded. The visual climb or descend alert clears after recapturing the target altitude or 30
wind
seconds F
. lying back inside the 150-foot capture window re-arms the alerter without any user interaction.
If your system is configured to output voice via an HS34 or AP74 module, the voice alerts “climb” or “descend”
t altitude and then adjust the
t
riggers and the bug alternates red and yello
button in
cklists and Data Panels
e
5 checklists or data panels. By default the FlightDEK-D180 is loaded with the following 5
are sounded, instead of tones. Additionally as you approach the altitude bug, the voice alert “altitude” is
sounded when crossing 500 feet away from the bug.
To simulate the altitude alerter on the ground, SYNC the altitude bug to your curren
altimeter setting up or down. When you adjust the altimeter setting enough that
window, observe that the audio alert t
he altitude is outside the 200-foot
w.
If you do not wish to use the altitude alerter function, push the ALM
the BUGS menu to toggle it to OFF.
LISTS – Using Che
FlightDEK-D180 Pilot’s User Guide
5-5
Note that the lists accessed from the EFIS and EMS menus are the same. Only one set of lists are uploaded via th
Dynon Support Program.
The Dynon Support Program allows you to enter your own checklists or select from included data panels. These
checklists and data panels can then be uploaded to your FlightDEK-D180 for quick access from the main menu or from
your screen rotation. Data panels and checklists can be included beneath 5 user-configurable categories and each
category can contain up to