Dynon Avionics FlightDEK-D180 Pilots Users Guide - Manual (Page 47)

EFIS Operation
5-10 FlightDEK-D180 Pilot’s User Guide
Abbreviation Display Item Function
CDI Course Deviation Indicator Toggles and configures the display of the CDI and glideslope. Choosing “CDI”
causes the course deviation indicator to display above the slip/skid ball. Choosing
“CDI+GS” causes both the CDI and glideslope indicators to display, with the
glideslope indicator displayed next to the roll scale. If the CDI button status
displays “Y” or “CDI+GS” and no CDI or glideslope is displayed onscreen, the
FlightDEK-D180 cannot detect your NAV radio or GPS, there is no active course,
or there is no NAVSRC chosen on the HSI page.
CRS Course Pointer Toggles the display of a “V”-shaped course pointer on the heading tape. Like the
CDI, this can only be displayed when the FlightDEK-D180 is receiving a valid
course from the NAV source selected on the HSI page. If the CRS button status
displays “Y” and no course pointer is displayed on the heading tape, the
FlightDEK-D180 cannot detect your NAV radio or GPS, there is no active course
set, or there is no NAVSRC chosen.
TRIM Elevator Trim Displays the elevator trim. This can only be displayed when an elevator trim sensor
is properly connected to the EMS connector, and configured in the EMS setup.
CHECK FIRMWARE VERSION
The EFIS > SETUP > VRSION menu gives you two important pieces of information: your FlightDEK-D180‘s current
firmware version; and the number of hours the FlightDEK-D180 has been on. If you require technical support or other
assistance from Dynon, please have your firmware version ready when you call or write.
INFO – Informational Items
In the EFIS > INFO menu, you have the option of displaying an
informational display item on either the left or right side, or
both. You may display a voltmeter (VMETER), g-meter