Dynon Avionics FlightDEK-D180 Pilots Users Guide - Manual (Page 51)

EFIS Operation
TIMER – Setting and using a timer
Enter the EFIS > TIMER menu. In the value setting box, the
DOWN or UP label is displayed, depending on which timer t
is currently selected. The currently running timer is displa
the Times Page, as described on page
ype
yed on
4-12. Use the following
points as you work with the timer.
 The UP/DN button toggles the menu and timer between an up timer and a down timer. When switching to an up
timer, the timer set value resets, allowing the up timer to count up from 0:00:00.
 To reset the timer, press the UP/DN button twice.
 To start the timer, press START. Once started, the button’s label changes to STOP. To stop the timer, press
STOP.
 To set the down timer, press HOUR, MIN, and SEC to adjust the timer to the desired value.
 You may not have an up timer and a down timer running at the same time.
Multiple Dynon products connected via a DSAB network share one timer. Starting, stopping, or configuring the
timer on one instrument causes all other instruments to reflect the change.
OATSET – Setting Temperature Offset
If you did not purchase an EFIS or EMS outside air temperature sensor from Dynon Avionics, you may still manually
adjust the OAT to an approximate value. With this manually entered information, the FlightDEK-D180 calculates and
displays true airspeed (TAS) and density altitude as it does when an OAT is connected. Ensure that you have indicated
that an EFIS OAT is not installed; enter the EFIS > SETUP > OAT menu and press INSTALLED until the value is “N.”
5-14 FlightDEK-D180 Pilot’s User Guide