Fcc information (for us customers) – Yamaha RX-497 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

IMPORTANT SAFETY INSTRUCTIONS

FCC INFORMATION (for US customers)

IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!

This product, when installed as indicated in the

instructions contained in this manual, meets FCC

requirements. Modifications nol expressly approved by

Yamaha may void your authority, granted by the FCC, to

use the product.

IMPORTANT:

When connecting this product to

accessories and/or another product use only high quality

shielded cables. Cable/s supplied with this product MUST

be used. Follow all installation instructions. Failure to

follow instructions could void your FCC authorization to

use this product in the USA.

NOTE:

This product has been tested and found to comply

with the requirements listed iti FCC Regulations, Part 15
lirr Class "B” digital devices. Compliance with these
requirernetits provides a reasonable level of assurance that
your use of this product in a residetilial envirotimeiit will
not result iti harmful intcrlercnce with other electronic

devices.
This equipment gencrates/uses radio frequencies and, if

not installed and used according to the instrucliotis found
iti the users manual, may cause interference harmful to the
operation of other electronic devices.

Compliance with FCC regulations does tiot guarantee that

interferetice will not occur in all installations. If this

product is fotitid to be the source of interference, wiiich
can be dctermitied by turning the unit “OFF" and “ON",
please try to eliminate the problem by iisitig one of the

following measures:

Relocate either this product or the device that is being
affected by the interference.

Utilize power outlets that arc on different branch (circuit
breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient
the antenna. If the antenna lead-in is 300 ohm rihbon lead,

change the lead-in lo coaxial type cable.

If these corrective measures do not produce satisfactory

results, please contact the local retailer tiuthorized lo
distribute this type of product. If you can not locate the

appropriate retailer, please contact Yamaha Electronics

Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA

90620.

The above statements apply ONLY to those products
distributed by Yamaha Corporation of America or its
subsidiaries.

Advertising