Xm satellite radio, Remote control – Yamaha RX-497 User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
XM Satellite Radio
Error message
Cause
Remedy
¡“'L| j!!!' r'l/' M
krr
|!!!'
kj
The XM Connect-and-Play dieiUtl anlenna
acceiNiiory is not connected, or does not work
properly.
Check the XM Connect-and-Play digital anlenna accessory
connections.
j
i kn"j
The XM user encryption code is being updated.
Wait until the encryption code is updated.
kh'''j '!!r T
The signal is too weak.
Check the XM Connect-and-Play digital antenna accessory
connections and orient it for the best reception.
j |'''jTjj“« T i'.,j|"j
It lakes longer than four seconds for audio or
text data to be decoded.
Wait until the decoding process has finished.
nc'ir ¡”ij']'jr'
The XM Satellite Radio cdtannel you selected is
not currently broadcasting any signal.
Check the channel niunbcr again or select another XM
Satellite Radio channel.
.........
The channel station ID (SID) is no longer
available.
^
No artist narne/fealtire or song/program title is
available.
^
j'"'
Tj
...................
No channels are available for the selected
citt.egory.
Select another channel category by pressing CATEGORY on
the front panel (or A-E/CAT. < / > on the remote control)
repeatedly.
Remote control
Problem
Cause
Remedy
See
page
The remote control
does not work nor
function properly.
Wrong distance or angle.
The remote control will function within a maximum
range of
6
m (19,7 ft) and no more than 30 degrees
off-axis from the front panel.
9
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
sniking the remote control sensor of this
unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
9
The remote control ID and this unit’s ID
do not match.
Switch the remote control ID or this unit’s ID.
35. 36
The remote control code was not correctly
set.
Try setting another code of the same manufacturer
iisrng ‘TIST OF REMOTE CONTROL CODES” at
the end of this manual.
41
Even if the remote cont'ol code is
coiTecliy set, there are some models that
do not respond to the remote control.
Use the supplied remote control for the components.
—
44