Yamaha RX-497 - Manual (Page 40)

ADVANCED SETUP
Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
Switching the remote controi ID
You can select the unit you want to operate with the
remote control by switching the remote control ID.
1 Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
Press A/B/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
N o te
Tile settings you made are reflected next time you turn on the
power of this unit-
while holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
■:Sg
Remote
control ID*
(this unit’s
setting)
Function Code number
IDl
To operate this
unit using an
alternative code.
801
ID2
(default setting)
To operate this
unit using the
default code.
802
* 5\Tieu you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
N o te
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).
36