Yamaha RX-497 - Manual (Page 45)

REMOTE CONTROL FEATURES
Setting remote control codes
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input source. For a complete list of available remote
control codes, refer to “LIST OF REMOTE CONTROL
CODES” at the end of this manual.
The following table show the default component category
(Library) and the remote control code for each input
source.
Remote control code default settings
* You can only set the TV remote eoutrol codes for the DT\7
CBL button. However, other remote control codes can be set
for any input selector buttons except DTV/CBL.
N o te
You may not be able to operate your other YAMAHA
components even if the YAMAHA remote control code is
initially set as listed above. In this case, try' setting other
YAMAHA remote control codes. •
1 Press and hold CODE SET on the remote
control and then press one of the input
selector buttons on the remote control to
select the input source you want to set up.
iioBMl
Is«»- ■'
1
wi
5'iil
Input
source
Default
component
category
(Library)
Manufacturer
Default
YAMAHA
code
CD CD YAMAHA 199
MD/TAPE TAPE YAMAHA 499
DVD DVD YAMAHA 699
DTV/CBL — — —
VCR — — —
PHONO — — —
N o te
You must press and hold CODE SET throughout this operation.
2 While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
remote control code for the selected input
source.
When the setting succeeds, “PRESET OK” appears;
however, when it does not, “PRESET NG” appears m
the front panel display.
To reset the code, enter the default code for each
input source listed in the remote control code default
settings table.
m m m
N o te s
• If die manufacturer of your component has more than one code.
try setting each of them until ymi find the correct one.
‘ You can only assign one remote control code to each input
selector button.
41