Yamaha CINEMASTATION NX-C300 - Manual (Page 36)

DVD Setup Menu Options
Progressive function - (on/off)
The progressive scan display present 60 complete
frames per seconds, rather than 30 frames per
second of interlaced scanning (ordinary normal TV
system). With nearly double the number of lines,
progressive scan offers higher picture resolution
and eliminates bothersome motion artifacts those
jagged edge on moving objects.
IMPORTANT!
Before enabling the progressive scan
function, you must ensure:
1) Turn on yourTV progressive scan function (refer
to yourTV owner’s manual),
2) You have connected the DVD receiver
to yourTV usingY P b P r (see“Connecting a
Progressive Scan TV” on page 14),
O In ‘VIDEO SETUP PAGE’, press AV to highlight
[PROGRESSIVE], then press ►.
OFF
Select this to disable progressive scan function.
ON
Select this to enable progressive scan function.
0 Press AV to select a setting and press ENTER
(OK) to confirm.
Follow the instructions shown on the TV to
confirm the selection (if any).
If a blank/distorted TV screen appears, wait for
15 seconds for auto recovery to activate.
Picture settings
This receiver comes with three predefined sets of
picture color settings and one personal setting that
you can define yourself.
O
In ‘VIDEO SETUP PAGE’, press AT to highlight
[PICTURE SETTING], then press ►.
STANDARD
Select this for the standard picture setting.
BRIGHT
Select this to make the TV picture brighter.
SOFT
Select this to make the TV picture softer.
PERSONAL
Select this to personalise your picture color by
adjusting the brightness, contrast, tint and color
(saturation).
TIPS.-..........To return to the previous menu, press -
To clear the menu, press SET UP,
o Press AT to select a setting and press ENTER
(OK) to confirm,
O If you select [PERSONAL], proceed to steps
o~o
The‘PERSONAL PICTURE SETUP menu
appears.
PERSONAL PICTURE SETUP
CONTRAST
TINT
COLOR
O Press AT to highlight one of the following options.
BRIGHTNESS
Increase the value to brighten the picture or vice
versa. Zero (0) is the average setting value.
CONTRAST
Increase the value to sharpen the picture or vice
versa. Zero (0) is the average contrast.
TINT
Increase or decrease the value to change the color
phase of the picture. Zero (0) is the average setting
value.
COLOR
Increase the value to enhance the color in your
picture or vice versa. Zero (0) is the average color
setting value.
0
Press ► to adjust the setting that best suits your
personal preference.
0
Repeat steps
O 0
to adjust other color features
if desired.
O Press ENTER (OK) to confirm.
Selecting the black level (U.S.A.
model only)
If you set the TV type to NTSC, set Black level shift
to ON.This will improve the color contrast during
playback.The black level setting has no effect if the
TV type is set to PAL.
ON
Select this to enhance the black level,
OFF
Select this for the standard black level setting.
32