Names of controls, Power switch, Cassette holder – Yamaha DTR2 User Manual
Page 5: Input selector, Skip play switch, Repeat button, Program button, Clear button, Call button
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NAMES OF CONTROLS
Front panel
© POWER switch
Turns the power on and off.
© Cassette holder
Holds the digital audio tape.
®
INPUT selector
Set to DIGITAL to record from an audio source
connected to the DIGITAL INPUT terminals. Set to
ANALOG to record from an audio source connected to
the ANALOG INPUT terminals.
© REC fs (Recording Sampling Frequency) selector
When recording is performed using the ANALOG
INPUT terminals, the sampling frequency can be
switched to 44.1 kHz or 48 kHz.
® SKIP PLAY switch
Switches the skip play function.
® OPEN/CLOSE button
{ ± )
Press to open the cassette holder, press again to close
it.
® DISPLAY button
Selects either absolute time (ABS) or individual tune
playback time (PROG) or tape counter (COUNTER).
When tapes which contain "TOC" signals are used, the
total number of tunes and total playback time are
displayed.
® COUNTER RESET button
Press to reset the tape counter (0000).
• Only effective in counter display mode.
® REPEAT button
Press to continuously repeat playback.
® PROGRAM button
Used for programming tunes.
® CLEAR button
Press to clear the input digit or programmed tune No.
® CALL button
Press to check the program contents.
® ABS (Absolute) TIME button
Press to input the specified time for absolute time
search.
® Digit buttons
Used to select desired tune numbers for program
playback or direct playback. These buttons are also
used to input the specified time for absolute time
search.
® REC (Record) LEVEL control
Used to adjust the recording level when recording from
an audio source connected to the ANALOG INPUT
jacks. This control can adjust the left and right channels
independently.
® PHONES jack
Connect stereo headphones to this jack.