Panasonic KX-P3124 - Manual (Page 112)

AGM (Alternate Graphics AGM will allow you to select Epson graphics while in the IBM mode.
Mode):
ASCII: “ASCII” is an acronym for “American Standard Code for Information
Interchange". In ASCII, each character has a unique code.
BASIC:
Baud (baud rate):
Bidirectional printing:
Binary:
Bit:
Bit-image graphics:
Buffer:
Byte;
BASIC is a commonly used microcomputer programming language.
Baud is a unit of data transmission speed between computer devices.
Can be but not necessarily equal to bits per second.
Processing speed is increased by bidirectional printing. That is, the
printer prints right-to-left as well as in the normal left-to-right manner.
Binary is a numbering system using the two digits of zero (0) and one (1).
Bit is an abbreviation for “binary digit (0—1)”, and is the smallest unit of
information used by a printer or computer.
Graphics which are created through a series of dots printed in vertical
columns.
Buffer is an area of memory which stores data temporarily.
Byte is the unit of information used by a printer or computer. One byte is
equivalent to eight (8) bits.
Character set:
Code page:
Control codes:
cpi:
cpI;
cps:
Character set is the set of characters, numbers, and symbols available for
printing.
The computer system stores characters and numbers as a numerical
data. The code page is a table which is used to change them into the
numerical data.
Control codes are commands from the computer to the printer that are
non-printable characters. They are used to control printer functions.
“cpi" is an abbreviation for “characters per inch”, and means the maxi­
mum number of characters printed in one horizontal inch.
“cpi” is an abbreviation for “characters per line”, and means the maxi­
mum number of characters printed on one line.
“cps” is an abbreviation for “characters per second”, and means the
number of characters printed in one second.
CR (Carriage Return): “CR” is a control code that returns the printhead to the left margin.
112