Panasonic KX-P3124 - Manual (Page 95)

“ÜljiMaiSgODSS^
Symptom Possible Cause Probable Solution
Printout is double-spaced AUTO LF is ON Set AUTO LF to OFF
{Q^ P. 60, 67)
Keeps printing on the same
line Computer is not sending a LF
command Set AUTO LF to ON
p. 60, 67)
Wrong character set printed Wrong character set selected Set the character set as
required
((^ P. 59, 66)
Cannot change print style
from computer
PANEL LOCK is ON for FONT
and PITCH modes
Set PANEL LOCK to OFF
(Q^ P. 59, 64)
*KX-PS14 {serial interface
board) is installed but cannot
print
l/F is set to PARALLEL Set l/F to SERIAL and select
desired parameters
(D^ KX-PS14 manual)
*Cannot use parallel interface
when installing serial
interface board
KX-PS14
l/F is set to SERIAL
Set l/F to PARALLEL
KX-PS14 manual)
KX-PS13
Parallel interface cannot be
used when a KX-PS13 is
installed
Remove KX-PS13 when using
parallel interface
(Q^ KX-PS13 manual)
*Printer does not print in color Color kit (KX'PCK11) is not
installed
Install the color kit
(KX-PCK11)
Incorrect emulation is set Select proper printer driver In
your software (Q^ P. 38)
*Prints in 2 different colors Yellow color gap lever of color
kit is not in the proper position
Set color gap lever of color kit
to the proper position
(0^ “Color Adjustment" in the
color kit installation manual)
Reinstall the color kit
(Q^ “Installing the Color Kit”
in the color kit installation
manual)
Table 6.1 Troubleshooting
* Option
© Press [ON LINE) repeatedly until the page is completed.
@ Install the new paper.
© Press [ON LINE].
•The paper out detector can be disabled through the Function mode.
Note:
•Your printer has a paper out detector. When an out of paper condition occurs, printing stops,
the printer goes to the OFF LINE mode, and the PAPER OUT light starts blinking. To continue
printing to the end of the current page, follow the steps below.
5*
(D
3
D)
3
o
<D
fio
“I
O
c
<D
CO
3"
o
o
5'
(Q
95