Panasonic KX-P3124 - Manual (Page 96)

Q)
<D
fi)
3
o
(D
Error Messages Possible Cause Probable Solution
CANT LOAD
MACRO
Printer can’t load a MACRO in Hex.
Dump mode Power off then on
Some data remains in printer Press ON LINE switch to print out
remaining data
CANT PRINT
OUT Some data remains and printer can’t
output
With paper installed press ON LINE
switch to print out remaining data
CANT SET
MARGIN Margins are set incorrectly Set margins correctly
{(sr P. 58, 63)
PAPER OUT Paper is not installed or is not under
platen
Install paper or load paper by
pressing LOAD/PARK switch
(t^ P. 24-36)
NO COLOR
RIBBON Printer can’t perform color printing
with a black ribbon or without a color
ribbon
Install a color ribbon
(D^ The color kit installation manual)
NO COLOR KIT Printer can't perform color printing
without a color kit and a color ribbon
Install a color kit and a color ribbon
(D^ The color kit installation manual)
OVERLOAD Path of printhead is blocked Power off then eliminate
the blockage
Power on to resume printing
Paper is jamming Power off then remove the jammed
paper and set paper correctly
Power on to resume printing
PRINTHEAD
HOT Printhead is overheated and printer
pauses until the printhead
temperature decreases
Automatic recovery
NO REV LF/PULL REV LF/PULL is OFF Set REV LF/PULL to ON
(tl^ P. 60, 68)
CANT BACK
PAPER
Printer can’t back paper past
printable area Do not back paper past printable
area
TOP MARGIN Printer can’t back paper past top
margin (only when a top margin is
set)
Do not back paper past top margin
or reset top margin to 0
CANT SET TOF Printer can't set top of form Check your paper installation
((^ P. 24-36)
EEP ROM
ERROR EEP ROM chip is out of order Contact a local Authorized Service
Center
RAM ERROR RAM chip is out of order
Table 6.2 Error messages
o
c
<D
CO
3-
o
o
(O
96