Panasonic KX-P3124 - Manual (Page 70)

Moigl §sífea[g [Ditefe
C
3
o
5‘
3
S
o
Q.
(D
This Setup Disk can only be used in an IBM-PC or a compatible computer with a 3.5" floppy
disk drive.
Before you use the Setup Disk, it is recommended that you make a back-up copy and store the
original in a safe place.
This printer has been factory set to operate with most of the popular software packages. In
most cases there will be no need to change the Function mode items. Refer to pages 58—60
to verify that the factory settings meet your requirements. If no changes are required, you
should be ready to print.
Note:
• Use the DISKCOPY command of the operating system to make a back-up copy. Refer to your
DOS manual for further information.
•You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather
than reading them from the Setup Disk each time a change is necessary. Either method is
acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, follow the steps
below:
1. Insert the Setup Disk into drive A or B.
2. Type A: {or B:) and press Enter.
3. Type INSTALL and press Enter.
This procedure automatically creates a directory called 3124 and copies all of the programs
from your Setup Disk onto your C Drive.
At your C:\> prompt, type CD 3124 and press Enter.
Type SETUP and press ( Enter 1 to complete the procedure. Be sure to type this
instruction as one word.
If not, you will receive a Syntax error message.
Running the Setup Program
1 Insert your Setup Disk into either drive A or B.
<For Dos>
2
3
4
Type A: (or B:) and
press ( Enter),
Type SETUP
Press ( Enter).
You will receive a “Please wait!I” message
until your first screen automatically appears.
<For WINDOWS>
2
3
4
Select Run from the File
menu.
Type A:\SETUP
(or B:\SETUP)
Click
I
OK
I
(or Press ( Enter]).
70