For output, Connections for video equipment – Panasonic DT2750MS User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.
Turn off the power switches of the video equipment and/or your monitor if they are now on.
2.
Connect the RCA cables (these cables are not supplied with the monitor) to the video equipment and the
monitor as shown in the following figures.
3.
If it has not been installed, first connect one end of the power cable to the monitor and then the other end to
the AC outlet*.
4.
Turn on the power switches of the monitor and the video equipment.
5.
Select “AVr or “AV2” by pressing front button AVI or AV2 or pressing the AVI or AV2 key on the remote
control unit {see page 21).
Note: When selecting “AVI”, either the RCA jack or BNC connectors is available for video.
Connections for video equipment
For OUTPUT:
The signal which is selected by the AVI or AV2 button/key and displayed on the screen is available on the
output connectors.
6.
This completes the installation of your monitor.
Caution: *lf the AC outlet is of the two prong type, please consult with a licensed electrician.
Note:
RCA jack named “VIDEO” is connected to BNC jack named “AV OUT” directly. Do not connect
both connectors at the same time.
15