How to adjust, Detail operation – Panasonic DT2750MS User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Detail operation
Mode
White Balance R
High Light
then JLaR
Mode 1
How to adjust
1.
Press MENU button a few times to select Mode 1.
2.
Press + or - button a few times to select “C. TEMP” control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4.
Press + or - button a few times to select “user H” control.
5.
Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL R” control.
7.
Press SET button. Then the sub-menu appears on the CRT screen.
B.
Press + or - button a few times to get the desired level.
‘V’: set the red high light intensity higher.
(set the picture white balance reddish)
set the red high light intensity lower.
(set the picture white balance towards cyan)
9.
Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user H” mode, item 2 through 5 can be
skipped.
White Balance G
High Light
then
Mode 1
1.
Press MENU button a few times to select Mode 1.
2. Press + or - button a few times to select “C. TEMP” control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4.
Press + or - button a few times to select “user H” control.
5. Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL G” control.
7.
Press SET button. Then the sub-menu appears on the CRT screen.
8.
Press + or - button a few times to get the desired level.
‘V: set the green high light intensity higher.
(set the picture white balance greenish)
set the green high light intensity lower.
(set the picture white balance towards magenta)
9. Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user H” mode, item 2 through 5 can be
skipped.
White Balance B
High Light
Mode 1
R-»-+B then
1.
Press MENU button a few times to select Mode 1.
2. Press + or - button a few times to select “C. TEMP" control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4.
Press + or - button a few times to select “user H” control.
5.
Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL B” control.
7.
Press SET button. Then the sub-menu appears on the CRT screen.
6.
Press + or - button a few times to get the desired level.
‘V’: set the blue high light intensity higher.
(set the picture white balance bluish)
set the blue high light intensity lower.
(set the picture white balance towards yellow)
9, Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user H” mode, item 2 through 5 can be
skipped.
27