Panasonic DT2750MS - Manual (Page 32)

Detail operation
Item Mode How to adjust
Raster Rotation
O
Mode 2
1 . Press MENU button a few times to select Mode 2.
2 . Press + or - button a few times to select “ROTATION” control.
3. Press SET button.
4 . Press + or - button a few times to adjust the rotation.
rotate the raster clockwise,
rotate the raster counter-clockwise.
5 . Press SET button to store the correction in the memory.
H. Moire HM Mode 2
H. Moire control can smoothen “wrinkles” or “waves” that may occur in some
parts of a picture.
I. Press MENU button a few times to select Mode 2.
2 . Press + or - button a few times to select “H. MOIRE” control.
3. Press SET button.
4 . Press + or - button a few times to adjust the moire.
increase the level of moire concealment,
decrease the level of moire concealment.
Concealment is effective in the horizontal direction.
5. Press SET button to store the correction in the memory.
Input Signal Status
Display ^
Mode 2
1 . Press MENU button a few times to select Mode 2.
2 . Press + or - button a few times to select “SIGNAL” control.
3. Press SET button.
Then the screen indicates “fH” and “fv”.
Press SET or MENU button to return to Mode 2.
Monitor ID Code
Selection
ID
Mode 2
The monitor identification No. (Monitor ID) can be set up to 10 (0 - 9) on DT-
2750MS. When you use plural units of DT-2750MS simultaneously, you can
address via the wireless remote control, an individual DT-2750MS.
(See the wireless remote control for the detail operation)
7. Press MENU button a few times to select Mode 2.
2 . Press + or - button a few times to select “ID CODE” control.
3. Press SET button. Then the sub-menu appears on the CRT screen.
4 . Press + or - button a few times to select the monitor ID code.
5 . Press SET button to store the correction in the memory.
RS-232C Speed
Selection
RS
Mode 2
7, Press MENU button a few times to select Mode 2.
2. Press + or - button a few times to select “RS-232C” control.
3. Press SET button. Then the sub-menu appears on the CRT screen.
4 . Press + or - button a few times to select the RS-232C speed.
5. Press SET button to store the correction in the memory.
Clamp Pulse Width
Selection
cs
Mode 2
1 . Press MENU button a few times to select Mode 2.
2. Press + or - button a few times to select “Clamp Pulse Width Selection”
control.
3. Press SET button. Then the sub-menu appears on the CRT screen.
4 . Press + or - button a few times to select “NORMAL” or “NARROW”.
Note: Usually you can select “NORMAL”. But, if you see the video sag on
the CRT screen, select “NARROW”.
5. Press SET button to store the correction in the memory.
Aspect Ratio
Selection
AP
Mode 2
1 . Press MENU button a few times to select Mode 2.
2. Press + or - button a few times to select “ASPECT’ control.
3. Press SET button. Then the sub-menu appears on the CRT screen.
4 . Press 4 - or - button a few times to select the aspect ratio.
5. Press SET button to store the correction in the memory.
31