Mode, How to adjust, White balance r low light – Panasonic DT2750MS User Manual
Page 29: White balance g low light, White balance b low light
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mode
How to adjust
White Balance R
Low Light
then
Mode 1
1.
Press MENU button a few times to select Mode 1.
2.
Press + or - button a few times to select “C. TEMP” control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4.
Press + or - button a few times to select “user L” control.
5.
Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL R” control.
7.
Press SET button. Then the sub-menu appears on the CRT screen.
8.
Press + or - button a few times to get the desired level,
‘V’: set the red low light intensity higher.
(set the picture white balance reddish)
set the red low light intensity lower.
{set the picture white balance towards cyan)
9.
Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user L” mode, item 2 through 5 can be
skipped.
White Balance G
Low Light
then
Mode 1
1.
Press MENU button a few times to select Mode 1.
2.
Press + or - button a few times to select “C. TEMP” control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4. Press + or - button a few times to select “user L” control.
5. Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL G” control.
7. Press SET button. Then the sub-menu appears on the CRT screen.
8.
Press + or - button a few times to get the desired level.
‘V’: set the green low light intensity higher.
(set the picture white balance greenish)
set the green low light intensity lower.
(set the picture white balance towards magenta)
9.
Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user L” mode, item 2 through 5 can be
skipped.
White Balance B
Low Light
Mode 1
R-^B then
3
1.
Press MENU button a few times to select Mode 1.
2.
Press -»-or - button a few times to select “C. TEMP” control.
3.
Press SET button. Then the sub-menu appears on the CRT screen.
4. Press + or - button a few times to select “user L” control.
5. Press SET button. Then the main-menu appears again.
6.
Press + or - button a few times to select “WHT BAL B” control.
7. Press SET button. Then the sub-menu appears on the CRT screen.
8.
Press + or - button a few times to get the desired level,
‘V’: set the blue low light intensity higher. •
(set the picture white balance bluish)
set the blue low light intensity lower.
(set the picture white balance towards yellow)
9.
Press SET button to store the correction in the memory.
Note: If “C. TEMP” control is kept in “user L” mode, item 2 through 5 can be
skipped.
28