X —a—....................^4, Vol.um – Panasonic DT2750MS User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Press - button or + button to select the control mode. When + button is pressed, the selected control mode
changes to the right direction as follows;
41—-0-^3^....... .. —4D
When - button is pressed, the selected control mode changes to the left direction as follows:
<]!)— <]X —A—....................^4^
The icon of the selected control blinks. Also, the control name is shown on the bottom-left of the “on screen
display” menu.
Note: Unavailable icons will be skipped:
3.
To activate the selected control, press SET button.
The control level indicator menu appears on the bottom side of the CRT screen as follows:
Selected input terminal is shown. Control data (0-63) is shown.
Selected control is shown.
RGB1
VOL.UM
SET ^ save
31
MENU^ quit
4.
To increase the control level, press + button “O”.
To decrease the control level, press - button “<l”.
Then the control data and the control level icon changes.
5.
If you are satisfied with the resulting control level, press SET button.
Then the control level is stored in the memory inside of the monitor and the control level indicator menu on
the CRT screen disappears and Menu mode 1 or Menu mode 2 screen appears on the CRT screen.
Note: To cancel the control level, press MENU button. Then the control level returns to the previous level
and Menu mode 2 screen appears on the CRT screen.
6.
If the adjustment is finished, press MENU button once or twice until the menu mode screen disappears.
If the MENU button is not pressed for 60 seconds after the last operation, control mode menu screen
disappears automatically.
If you want to adjust the other, go back to steps 2 through 5.
25