Brookfield YR-1 Rheometer - Manual (Page 29)

Brookfield Engineering Labs., Inc. Page 29 Manual No. M02-215-B0412
After removing the spindle and pressing any key, and checking the level, the YR-1 begins its
Autozero. The following is displayed during the autozero (with AUTOZEROING flashing):
AUTOZEROING
PLEASE WAIT
Figure III-4
When the autozero is complete, the Default Screen (Figure III-5) is displayed.
III.2 The Default Screen
The Default Screen is shown below:
#5 Sample Tst
START TEST
↑↓
Figure III-5
The program number (#0 through #9) and the program name (in this case, “Sample Tst”) are dis-
played on the top line. START TEST is flashing, indicating it is the current menu selection.
Note: If the program number chosen has no program loaded, the word EMPTY is displayed
as the program name.
Pressing either the ↓ or ↑ key causes the bottom line to cycle between that shown in Figure
III-5 and Figure III-6.
#5 Sample Tst
PRINT TEST ↑↓
Figure III-6
Pressing the Enter key selects the option that is flashing, causing the bottom line to stop flashing
and the top line to start flashing. The top line is now the active line, allowing you to select which
program to use. Pressing the ESC key, when Figure III-5 or III-6 is displayed, has no effect.
III.3 Running a Program
When the default screen in Figure III-5 is displayed and Start Test is the option displayed on
the bottom line, pressing the Enter key displays the following screen: