COP-USA CM260IR-IP - Manual (Page 25)

Page 21 2 Mega Pixel IP Camera User Manual
5.4.4
Alarm Input Trigger
1. Enter “Alarm Configuration” Æ “Alarm Input Trigger” to see a screen as shown below:
2. Select the sensor at the “Sensor” pull down list and set the sensor name and alarm type: NO
and NC.
3. Enable alarm and select alarm holding time.
4. Set alarm trigger options. The setting steps are the same with that of motion detection
trigger. Please refer to motion detection trigger chapter for details.
5. Apply settings to all by clicking “Copy” button, which can quickly set the same settings for
all sensors.
5.4.5
Alarm Input Schedule
Go to “Alarm Configuration” Æ “Alarm Input Schedule” as shown below: