COP-USA CM260IR-IP - Manual (Page 7)

Page 3 2 Mega Pixel IP Camera User Manual
2
Installation
2.1
Install IP-CAM
Before you start, please make sure that the wall or ceiling is strong enough to withstand three
times the weight of the camera and check whether the power supply is in conformity with
your AC outlet.
The mounting steps are as follows:
ʒ Attach the drill template to the place where you want to fix the camera and then drill 4
screw holes according to the drill template.
ʓ Route the cables and connect the power cableˈmicrophone cable and network cable.
ʔ Secure the mounting base with camera to the ceiling or wall with screws as shown below.

ʕ Three-axis adjustment. Before adjustment, preview the image of the camera on a monitor
and then loosen the lock screws to adjust as shown below.
z Loosen the lock screw 1 to adjust the panning position of the camera. The adjustable range
is from 0° to 360°.
z Loosen the lock screw 2 to adjust the azimuth angle of the image. The adjustable range is
from 0° to 360°.
z Loosen the lock screw 3 to adjust the tilting position of the camera. The adjustable range is
from 0° to 90°.
After you adjusted, tighten these lock screws.
Ļ Focus and zoom adjustment (If the model you get doesn’t support to adjust zoom and
focus, please skip this step). Remove the lens cover and then adjust the focus and zoom
screws to get a clear image. Finally, tighten these two screws and the lens cover.