Cub Cadet Z-Force S Series - Manual (Page 24)

Z-Force-S
18
8. Remove the reverse pedal using a 7/16” wrench.
See Figure 4.3.
9. Remove the drive pedal using a 1/2” wrench.
See Figure 4.3.
10. Remove the eight screws that hold the floor pan to
the frame using a T-30 torx driver. See Figure 4.4.
NOTE: The two outboard screws next to the seat
box are longer than the rest. They also pass
through a pair of spacers.
11. Lift the floor pan off of the mower.
NOTE: Under the floor pan there are two spacers.
See Figure 4.5.
12. Install the floor pan by following the previous steps
in reverse order.
Figure 4.3
Reverse pedal
Drive pedal
Figure 4.4
Long
screw
Long screw
Figure 4.5
Spacers