Cub Cadet Z-Force S Series - Manual (Page 65)

Steering
59
18. Remove the input shaft from the inside of the hous-
ing. See Figure 6.44.
19. Inspect the bearings. If they are worn or rough, care-
fully drive the inner bearing out of the upper housing
using a pin punch and hammer. See Figure 6.45.
20. Drive the outer bearing out of the upper housing
using a pin or brass punch and hammer.
See Figure 6.46.
21. Thoroughly clean and degrease all parts.
22. Inspect all parts for signs of wear or damage.
NOTE: If the part has signs of wear or damage; discard
the part.
NOTE: If the two bushings in the bottom of lower gear box
housing are worn, replace the lower housing and
press in two new bushings.
Figure 6.44
Input shaft
Figure 6.45
Drive out the inner bearing
Figure 6.46
Outer
bearing