Cub Cadet Z-Force S Series - Manual (Page 34)

Z-Force-S
28
9. Disconnect the reverse switch harness from the
conduit clip on the right side of the seat box.
See Figure 4.27.
10. Remove the four screws (two on each side) that
hold the seat box assembly to the frame using a 1/
2” wrench. See Figure 4.28.
11. Lift the seat box assembly off of the mower.
12. Install the seat box by following the previous steps
in reverse order.
13. Test drive the mower in a safe area before returning
it to service.
Figure 4.27
Reverse switch harness
Figure 4.28
Screws