Cub Cadet Z-Force S Series User Manual
Page 63
Advertising
Steering
57
12. Remove the input sector gear. See Figure 6.38.
NOTE: Some gearboxes were built with a spring washer
on top of the sector gear. If the sector gear is being
replaced, discard the spring washer.
13. Inspect the input sector gear bushings for damage
and/or signs of wear. If they show signs of wear or
damage, press both of the bushings out of the input
sector gear using a press. Then install new bush-
ings. See Figure 6.39.
14. Remove the thick washer. See Figure 6.40.
Figure 6.38
Input sector
gear
Figure 6.39
Inspect the
bushings
Figure 6.40
Thick washer
Advertising